Do you have a tire gauge. I checked the tire pressure and its right i reset while stopped and still the light is on.
My low tire pressure light on my 2007 335i will not stay off after i have reset it.
2007 bmw 335i low tire pressure light reset. The technician check the sensors and they are fine. I show you how to reset the low tire pressure warning system light on a bmw. Watch as ross demonstrates how to reset the tire press warning light on a 2010 bmw e90 efficientdynamic effdyn.
Adjust your tyre pressures on all four wheels. Did you read the last sentence. You pump up your tire but this light remains.
The correct settings are in the manual or on the sticker on the drivers side door opening. The tire pressure is correct. Tpms sensor is.
My car is 07 335i any other ideas. It shows all four tires are low. Press and hold down the reset button sometimes located under the steering wheel until the low pressure light blinks three times.
The tire pressure is correct. Put the key in the ignition and turn it to the on position but do not start the car. Appreciate 0 quote 03 19 2011 06 24 pm 8.
2007 e92 335i sold. Bmw tpm light or warning message may come on when there is a loss of air pressure in one or more tires. The purpose of the tpms tire pressure monitoring system on bmw is to alert you when tire pressure is too low and could to create unsafe driving conditions if the light is illuminated it means your tires could be underinflated which can lead to undue tire wear and possible tire failure.
Have you checked your tire pressure. Appreciate 0 quote. It shows all four tires are low.
As a bmw tire pressure monitoring system detects a 20 loss in tire pressure it triggers a tpm warning to alert the driver. This may also apply to other models. Here is how to switch it off.
My low tire pressure light on my 2007 335i will not stay off after i have reset it. If the tire pressure is correct you may be getting a tpm malfunction or inactive errors because. Check your owner s manual for the location of the tpms tire pressure monitoring system reset button.
Think it should be 2 1bar front and 2 3 bar rear if you don t have the idrive. The technician check the sensors and they are fine.
Comments
Post a Comment